Table of Contents
Advertisement
Installation
Fixed rack installation
System 40 systems are either shelf mounted or mounted directly in a rack.
Rack mount
Table 1-1
System 40 rack assembly parts
Quantity
2
Bracket, rear support
10-32 ×
4
Phillips pan head screw
8
Fastener, captive nut
10-32 ×
8
Parts list
Table 1-1 lists the supplied parts required to rack mount a typical System 40 chassis.
Rack preparation
1. Select a location in the rack.
2. Hold up the system at the selected location in the rack. The four slotted mounting holes in the front panel dictate the location
of the captive nut fasteners on the front rack rails. Mark where the fasteners are to be installed.
3. Referring to Figure 1-1, install four fasteners so the captive nuts are located behind the appropriate holes on the front rack rails.
Figure 1-1
Fastener installation
1-2
Description
Phillips pan head screw
Typically
2 1/4"
Keithley
part number
BR-21B
Attaches chassis rear to rear rack rails.
10-32x3/8 PPH
Attaches rear support brackets to chassis.
FA-148
Attaches rear support brackets and front
10-32x5/8 PPH
panel to rails.
Front Rack
Rail
Fasteners
Function
Advertisement
Table of Contents
