Led Description - H3C WX3500H Series Installation Manual

LED description

Table 32 LED description for the WX3508H access controller
LED
System status LED
100/1000BASE-T
autosensing Ethernet
copper port status
LED
1000BASE-X SFP
port status LED
Table 33 LED description for the WX3510H/WX3520H/WX3540H access controllers
LED
Power module 1
status LED
Power module 2
status LED
System status LED
Expansion slot status
LED
Mark Status
Flashing green (0.5 Hz)
Flashing green (4 Hz)
SYS
Steady red
Off
Steady green
Flashing green
N/A Steady yellow
Flashing yellow
Off
Steady green
N/A Flashing green
Off
Mark Status
Steady green
PWR1 Steady yellow
Off
Steady green
PWR2 Steady yellow
Off
Steady green
Flashing green
Flashing green
SYS
Steady yellow
Off
Steady green
Flashing green
MOD
Steady yellow
Off
44
Description
The system is operating correctly.
The system is starting up.
The system has failed POST, or a critical fault
has been detected.
The power is turned off, or the power system is
faulty.
A 1000 Mbps link is present on the port.
The port is receiving or transmitting data at
1000 Mbps.
A 100 Mbps link is present on the port.
The port is receiving or transmitting data at 100
Mbps.
No link is present on the port.
A 1000 Mbps link is present on the port.
The port is receiving or transmitting data at
1000 Mbps.
No link is present on the port.
Description
Power module 1 is operating correctly.
Power module 1 is faulty.
No power module is present.
Power module 2 is operating correctly.
Power module 2 is faulty.
No power module is present.
The system is starting up.
The system is operating correctly.
The system is downloading files.
The system has failed POST, or a critical fault has
been detected.
No power is input.
An interface card is present.
The hard disk is reading or writing data.
A failure has occurred.
No interface card is present.