Displaying The Operating State Of Power Modules; Rebooting The Device; Restrictions And Guidelines - H3C WX3500H Series Installation Manual

<H3C>display fan
Fan 1 State: Normal
Fan 2 State: Normal
Fan 3 State: Normal
Table 11 Command output
Field
Fan n
State

Displaying the operating state of power modules

Use the display power command to display the operating state of power modules.
<H3C>display power
Power 1 State: Normal
Power 2 State: Absent
Table 12 Command output
Field
Power 1, 2
State

Rebooting the device

To reboot the device, use one of the following methods:
•
Reboot the device at the CLI. You can remotely reboot the device in either of the following ways:
Reboot the device immediately by using the reboot command.
Schedule a reboot to occur at a specific time or date or after a delay by using the schedule
reboot command.
•
Power off and power on the device. This method cuts off the power of the device forcibly, which
might cause data loss. It is the least-preferred method.

Restrictions and guidelines

•
Before you reboot the device, perform the following tasks:
Use the save command to save the running configuration. For more information about the
save command, see configuration file management commands in H3C WX3500H Access
Controller Fundamentals Command Reference.
Use the display startup and display boot-loader commands to verify that you have
specified the correct next-startup configuration files and startup software images. If the main
startup software image is corrupt or does not exist, a reboot failure will occur. To avoid a
Description
Fan No..
Fan state:
•
Normal—The fan is operating correctly.
•
Absent—The fan is not in position.
•
Fault—The fan has failed.
Description
Power module No..
Power module state:
•
Normal—The power module is operating correctly.
•
Absent—The power module is not in position.
•
Fault—The power module has failed.
28