Connecting A Computer With Dvi Output Connector; Computer In 2 Connector; Contents - Toshiba TLP-X10E Manual

Connecting a computer with DVI output connector

You can project the picture by entering the digital RGB signals from a computer with DVI output connector.
Check that the power for the projector and computer is off before connecting the cables.
CONTROL USB MONITOR OUT COMPUTER IN 1
( Y/P /P
B
AUDIO AUDIO
OUT IN
To AUDIO IN jack
Notes
• The COMPUTER IN 2 connector can be used to input either digital RGB or analog RGB signals, depending on the connection cable used.
The projector's DVI connector is of the DVI analog & digital type. Check the type of output connector on the computer, then purchase the appropriate type
of connection cable. (To input analog RGB signals from a computer without a DVI connector, use a DVI cable on which the computer side connector is a
mini D-sub 15-pin connector.)
• You may not be able to connect some computers to the projector. For details, consult the dealer.
• Some computers may have output modes which are not compatible with this projector. Check the compatibility of the connectors, signal timing,
resolutions, etc.
COMPUTER IN 2
)
R
VIDEO IN
R - AUDIO - L VIDEO S-VIDEO
To COMPUTER IN 2 connector
Be sure to connect in the proper
direction.
DVI cable (not supplied)
Audio cable (supplied)
COMPUTER IN 2 Connector (DVI connector)
For use as both analog RGB2 input and digital RGB input. At shipping from
factory, the projector is set so that this connector cannot be selected by the
INPUT button. Change the setting on the menu screen when using.
AUDIO IN jack
For use as both audio signals for RGB input (analog RGB1/analog
RGB2/digital RGB) and Y/P /P input.
B R
To DVI output port
48
Computer
ø3.5mm Stereo mini-jack
To audio output port
23

CONTENTS