Connecting A Computer To The Projector - Toshiba SHX10 Quick Start Manual

1.
Open the battery cover on the back of
the remote controller.
3.
Close the battery cover on the back of the remote controller.
Replacing Remote Controller Batteries
Open the battery cover on the back of the remote controller, replace the old batteries with new ones, and
then close the battery cover.
Important! Important! Important!
To avoid running down the batteries, store the remote control unit so its buttons are not
pressed inadvertently.

Connecting a Computer to the Projector

You can use the projector to project an image of analog RGB output from a computer.
Important! Important! Important!
Always turn off the projector and the computer before connecting them.
Take care so the volume level of the computer is not set too high.
<Projector>
AV terminal
COMPUTER terminal
2.
To monitor terminal
(analog RGB output terminal)
Bundled mini D-Sub cable
Audio cable (commercially available)
EN-4
Load two new batteries into the case,
making sure that their positive (+) and
negative (–) ends are facing correctly.
<Computer>
To line output terminal
General Guide