Table of Contents
Advertisement
FULL MENU settings – Default setting (continued)
Control panel
Remote control
(Main unit side)
AUTO
KEYSTONE
INPUT
ON/STANDBY
LASER
AUTO
KEYSTONE
SET
VOL/ADJ.
L-CLICK
R-CLICK
4-c
VOLUME/ADJUST
ENTER
MENU
5
MENU
ENTER
EXIT
PIP
FREEZE
RESIZE
CALL
MUTE
TEMP LAMP
BUSY
When selecting "No signal power off", "Power on" or "Lamp power" in step 3.
4-c
AUTO
SET
4-c
Note
EXIT
5
The cooling sound changes according to the temperature inside the projector. When the
INPUT
lamp power setting is changed, the brightness changes immediately, but the cooling sound
level does not change immediately.
ON/STANDBY
5
ON
FAN
Notes
• If the power is turned off by pressing the ON/STANDBY button, the adjustments or settings
made are automatically stored in the memory. If the power cord is unplugged or if a power
failure occurs while the projector is on, the adjustments or settings are not stored in the
memory.
• The settings of "Default setting" are applied to all the input sources. (It is impossible to store
different settings for each input source.)
Press VOL/ADJ (+/-) to set.
No signal power off
OFF:
The power does not turn off automatically even if the no
signal status continues.
5 min.:
The power turns off automatically if the no signal status
continues for approx. 5 min.
Power on
Manual: The power turns on by pressing the ON/STANDBY button.
Auto:
When the power cord is plugged, the power turns on.
Press the ON/STANDBY button when turns power off.
Lamp power
Hi:
Set the lamp mode with brightness priority.
Low: Restrict the lamp output to reduce the cooling sound.
After the settings are finished, press EXIT.
EXIT
The menu screen disappears.
EXIT
70
CONTENTS
31
Advertisement
Table of Contents
