HK Audio COSMO Series Instructions For Use Manual page 34

COSMO Line Array – Instructions for use
11
Fold the fl ap of the lowest M/H unit in the array over into the
angle plate to set it the parking position.
12
Insert the two quick-release pins to attach the CRF-PB to the
lowest M/H unit in the array.
13
Insert quick-release pins to attach the pull-back frame's spacer
adapter at the proper position in the M/H unit's angle plate.
14
Hook the red tensioning end of the tensioning strap into the
CRF-PB's rear shackle and connect the loose and tensioning
ends of the strap.
- 34 -
15
Engage the tensioning strap's ratchet until all fl aps are fully
attached to the angle pins and you arrive at the desired preset
curvature.
Link
0°
1°
2°
3°
4°
5°
6°
7°
8°
9°
10°
Heads up: Always keep the area below the system
clear of people when raising or lowering it.
Heads up: You will feel some resistance when the
fl aps mid/high units butt up against the angle pins. Do not
tighten the strap any further as this may damage the
rigging hardware.
Rigging Manual 1.0