COSMO Line Array – Instructions for use
5
Attach the rigging frame's fl ap using the hole labeled link in
this M/H unit's rear angle plate. Now insert the loose end of the
tensioning strap with the crane hook into the rigging frame's
lower shackle.
6
Remove the quick-release pins of the lowest M/H unit on the
C-WB and lift the array until the entire load is suspended from
the lifting accessories and link pins.
Link
7
Now set all mid/high units' angle pins to the desired position on
0°
1°
the angle plate (see the pictured example for a 4° angle).
2°
3°
4°
5°
6°
7°
8°
9°
10°
Heads up: Remove and replace angle pins only when
the array is suspended and there is no load on them;
otherwise, you run the risk of pinch/crush injuries.
8
Link
0°
1°
2°
3°
4°
5°
6°
7°
8°
9°
10°
9
10
Repeat steps
speaker array are connected.
- 33 -
Rigging Manual 1.0
Raise the array just high enough for the next C-WB to slide in
below it.
Remove the C-WB's cover and insert the quick-release pins to
connect the front sides of neighboring M/H units (see step
above).
Attach the fl ap of the lowest suspended M/H unit to the link
hole of the top M/H unit on the C-WB (see step
6
through
10
until all components required for the
4
5
above).