Menu Functions - MG ZR Series Owner's Manual

MENU CONTROL FUNCTIONS

Menu Functions

The following tables identify the full range of functions obtainable
by pressing the menu button and then using the
Once an adjustment has been completed, press the menu button
once (or twice) to exit the menu and store the settings.
TAVOLUME Select to adjust audio volume for traffic broadcasts -
press controls to increase or reduce volume.
PEAK LVL With PEAK ON selected, display shows graphic
representation of radio output level - press
to select PEAK ON or PEAK OFF.
HICUT 1 HICUT enables or prohibits the automatic reduction of
HICUT 0 treble response in poor reception areas. HICUT 1
enables, HICUT 0 prohibits - press
select.
ON VOL
Default volume when audio is switched on - press
controls to increase or reduce volume.
MUTE LVL
Audio volume when mute is activated - press
controls to increase or reduce volume.
AUX ON This feature is not recommended for use with Rover 75
AUX OFF and MGZT models. Set to AUX OFF.
SENS Adjusts sensitivity of radio tuning - press
increase or reduce tuning sensitivity.
SCANTIME Select to adjust scanning time for radio and CD play -
press or to adjust (between 5 and 30 seconds).
PTY ON Select to enable or prohibit programme type (PTY)
PTY OFF selection - press the
PTY ON and PTY OFF.
110
Menu Functions
PTY LANG
or controls.
CLOCK ON
CLOCKOFF
CLOCKSET
12H MODE
24H MODE
controls
BEEP ON
BEEP OFF
REG ON
controls to
REG OFF
NOTE: Some of the above functions are not available during tape or CD
play, or MW/LW operation. Dependent upon the audio specification, one
of the following functions may also be available during CD or tape play:
CD DISP
or to
CDC DISP
controls to toggle between
RM ON
RM OFF
Select to change PTY language - press
English, French or German.
Enables or prohibits time display when audio is switched
off - press controls to toggle between 'CLOCK
ON' and 'CLOCK OFF'.
Select to adjust time display - press or
minutes or hours, and or to adjust the time.
Select to change clock display mode - press
to toggle between 12 & 24 hour modes.
An audible signal accompanies some operations where a
control is pressed for 2 seconds or more - press
to toggle between BEEP ON and BEEP OFF.
Reception of regional programme variations can be
enabled or prohibited - use the controls to select
REG ON or REG OFF.
Select to change single play CD display - press
controls to select TIME (display shows track playing
time) or PLAY (display shows track number).
Select to alter multi CD changer display - press
controls to select TIME (display shows track playing
time) or CD NO (display shows disc number).
Select to enable or prohibit radio broadcasts during
tape wind/rewind - press the controls to select.
or to select
to select
controls
or