Clock & Time; Setting The Time - MG ZR Series Owner's Manual

CLOCK Clock & Time
BND.TS TRAF.RDS
1 2 3 4 RPT
AS0049
To display the time, press and hold the clock control (2). The
display will be present for approximately two seconds.

Setting the time

1. Press the MENU button (1).
2. Press the or control until 'CLOCKSET' appears in the
display.
3. Press the control. The time shows in the display with the
minute figures flashing.
4. Adjust the minutes by pressing the
increase or down to reduce).
5. Once the minutes have been set, press the
cause the hour digits to flash.
6. Adjust the hours by pressing the
increase or down to reduce).
7. Once all changes are complete, press the MENU button
twice.
Clock & Time
Changing between 12 and 24 hour displays
1. Press the MENU button (1).
2. Press the
SRC
3. Press the
DMS
4. Press the MENU button to store your selection.
MENU
Clock displays when the audio is switched off
AUDIO X-BASS
5 MIX 6 With the starter turned ON:
The audio unit can be programmed to display the time, as follows:
1 2
1. With the audio switched on, press the MENU button (1).
2. Press the
3. Press the
4. Press the MENU button to confirm your selection.
With the starter turned OFF:
The time can be displayed when both the audio unit AND starter
switch are turned off, as follows:
• Briefly press the clock button (2). The time is displayed for
controls (up to
approximately 8 seconds.
control. This will NOTE: This feature is available in both 'CLOCK ON' and
'CLOCKOFF' modes.
controls (up to
or control until '12H MODE' or '24H
MODE' appears in the display.
controls to switch between displays.
or control until either 'CLOCK ON' or
'CLOCKOFF' appears in the display.
controls to switch between displays (with
'CLOCKOFF' selected, the time display is prohibited).
3
109