Setting The Hdmi _' Audio Mode; Viewing The Digital Signal Meter; Setting The Time Zone - Toshiba 40G300U Owner's Manual

4' Highlight
Done and press @
to save changes,
and go back to the Channel Labeling window.
Setting the HDMJ ®audio mode
To set tile HDMI audio mode:
MENU
1 Press O
and open the Sound menu.
2 Highlight Audio
Setup
and press @.
3 Press A or V to select HDNI 1 Audio and
then press 4 or _ to select the HDM[ 1 audio
mode
(Auto,
Digital,orAnalog). ( Auto is the
recommended mode.) See "Connecting an HDM[
or DV[ device to the HDM[ input" (_:_> page 16).
Auto
Digital
Analog
When viewing the HDMI 1 input, if
digital audio from the HDM[ input is
available, it will be output. [f not, the
TV will automatically detect and output
analog audio from the PC Audio input.
When viewing the HDMI 1 input,
digital audio from the HDM[ input will
be output.
When viewing the HDM[ 1 input,
analog audio from the PC Audio input
will be output.
4' To save your settings, highlight Done and press
O
Note: Because the PC and HDMI- 7 inputs
share the same set of analog audio inputs, the
PC Audio menu setting influences the HDM! 1
Audio menu setting. If PC Audio is set to "No,"
the HDMI 1 Audio setting changes to "Auto."
if PC Audio is set to "Yes," the HDMI 1 Audio
setting is set to "Digital" and is grayed out in
the menu. (Also see item 4 on page 12 and
"Setting the PC Audio" on page 50.)
Viewing the digital signal meter
You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
MENU
Press O and open the Setup menu.
Highlight
Installation
a nd press @.
3 A new set of [nstallation menu icons will appear.
Open the
Terrestrial
menu, highlight Signal
Meter, and press @.
4' Press AV4_ to select the antenna input and
digital channel whose signal you want to check.
Note:
• The physical digital channel number listed in
the Signal Meter screen may not correspond
to a virtual TV channel number. Contact your
local broadcasters to obtain the RF channel
numbers for your local digital stations.
• The signal strength does not change between
virtual channels on the same physical
channel.
To close the screen and return to the
Terrestrial menu:
Highlight Done and press @.
To return to normal viewing:
EXIT
Press O.
Setting the time zone
The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the correct
time zone information (_ page 58).
To set the time zone:
1 From the
Setup
menu, highlight
Installation
and
press @. A new set of Installation menu icons
will appear.
Highlight
Time Zone,
and press @.
3 Press 4 or I1_ to select the region, highlight D0ue,
and then press @.
(conrin ued)
33
40_46 55G300U EN-ASindb 83 2010/3/16 T@ 05:48:47