Setting The Hdmi ™ Audio Mode - Toshiba 26HL37 Owner's Manual

267470726HL37_EN.book Page 29 Friday, July 6, 2007 7:44 PM
Setting the HDMI
To set the HDMI audio mode:
1
Press Y and open the Set Up menu.
2
Highlight AV Connection and press T.
3
Press B or b to select HDMI1 Audio, and then press C
or c to select the HDMI audio mode (Auto, Digital, or
Analog). (Auto is the recommended mode). See
"Connecting an HDMI or DVI device to the HDMI input"
(- page 15).
AV Connection
PC/HDMI1 Audio
HDMI1 Audio
MENU Back EXIT
Note: Because the PC and HDMI1 inputs share the same set
of analog audio inputs, the PC/HDMI1 Audio setting
influences the HDMI1 Audio setting. If PC/HDMI1 Audio is set
to HDMI1, the HDMI1 Audio setting changes to Auto. If PC/
HDMI1 Audio is set to PC, the HDMI1 Audio setting is set to
Digital and will be grayed out.
When the sound is not audible:
Some of legacy HDMI sources may not work properly with
latest HDMI TV products, due to new standard adoption.
Please try to set Off the Lip Sync Latency feature. Your legacy
HDMI source should operate properly with this TV.
1
Press Y and open the Set Up menu.
2
Highlight AV Connection and press T.
3
Press B or b to highlight HDMI1 Audio.
4
Press and hold T for 5 seconds until the Lip Sync
Latency menu appears on the screen.
Lip Sync Latency
5
Press C or c to select Off.
6
Press p to turn the TV off and on again.
Note: Depending on the connected HDMI device, the sound
may be audible by turning it off and on again.
Chapter 5: Setting up your TV
™ audio mode
HDMI1
Auto
Exit
On
29
HL37 (E/F) Web 213:276