Auto Setup; Manual Setup; Setting The Sleep Timer; Using Regza-Link - Toshiba 40G300U Owner's Manual

Auto Setup
1 Press M_U and 4 or _ to select the Setup menu.
Press A or V to highlight Retwork Setup then
press EN@.
3 Press V to highlight Auto Setup, and then press
4 or _ to select 0u (default).
Manual Setup
This setup requires the data listed below. You can get
this data from either your [SP or the configuration
utility for your DSL/cable modem or router.
1
Press M_U and "9 or _ to select the
Setup
menu.
2 Press ,ik or Y to highlight
Network Setup,
and
then press @.
3 Press V to highlight Auto Setup, and then press
"_ or _ to select 0|f.
4. Press V to highlight
IP Address
field, and then
use the Number buttons on the remote control to
input the [P Address.
5 Press _!' to highlight the
Subnet Mask
field, and
then use the Number buttons to input the Subnet
Mask.
6 Press @.
Setting the sleep timer
You can set the sleep timer
to turn off the TV after a
set length of time (maximum of 180 minutes).
To set the sleep timer using the remote eontroh
SLEEP
Press (3 on the remote control to set the length of
SLEEP
time until the TV turns off. Repeatedly press O to
increase the time in 10-minute increments, or press
& or V" to increase or decrease the time in 10-minute
increments, to a maximum of 180 minutes.
56
To set the sleep timer using the on-screen
menus:
MENU Press (3 and open the Setup menu.
Highlight
Sleep Timer
and press @.
3 Press the Number buttons to enter the length of
time in 10-minute increments.
4. Highlight [}oRe and press @.
Note: When a power failure occurs, the
sleep timer setting may be cleared.
To display the remaining sleep time:
SLEEP
Press (3.
Note: k message will display on-screen when
there is one minute remaining on the sleep time_
To cancel the sleep timer:
SLEEP
Repeatedly press
0
until it is set to 0 minute.
UsingREGZA-LIRR ®
This is a new feature that uses CEC technology
and allows you to control Toshiba REGZA-LINK
compatible devices fi'om the TV remote via HDM[
connection (_:_ page 17).
When the Enable REGZA-LINK in the REGZA-
LINK setup menu (_:_ page 57) is set to 0u, the
following REGZA-LINK functions will be enabled.
REGZA-LINR ®playback device (DVD
player, etc.) control
With your TV's remote control, or using the REGZA-
LINK Player Control menu, you can control the
connected REGZA-LINK playback device you are
watching.
Available remote control key functions:
Before using the following key functions, first set the
MODE SELECT switch on the remote control to TV.
PLAY
C_3 Begins playback.
STOP
(2_) Stops playback
PAUSE/STEP Pauses the picture during play or record
mode.
SKiP
(!_E) Skips forward.
stop Skips backward.
(comin ued)
40_46 55G300U EN-ASindb 56 2010/3/16 T@ 05:4&16