Using The Pc Settings Li:atulx; Setting The Pc Audio - Toshiba 40G300U Owner's Manual

5 Press _ to select On. When the control panel
is locked and any button o13the control panel
(except POWER) is pressed, the message "NOT
AVAILABLE" appears.
To unlock the control panel:
Select 0fl in step 5 above, or press and hold the
VOLUME- button on the TV control panel for about
10 seconds until the volume icon appears.
Using the PC settings feature
You can view an image from a PC on the TV screen.
When a PC is connected to the TV's PC IN
terminal, you can use the PC Settings feature to
make adjustments to the image. If the edges of the
picture are cut off, readjust the
Horizontal Position
and Vertical Position. [f the picture is affected by
interference, readjust the CJ0CkPhase and SampJing
Clock.
To adjust the PC settings:
1 Repeatedly press _ to select PC input mode
(_:_> "Selecting the video input source to view"
page 35).
MENU
2 Press O
and open the Setup menu.
3 Highlight PC Settings and press @.
Note: lf a PC is not connected or there is no
pc input signal this feature will be grayed
out in the Setup menu.
4' Press lk or V to highlight the item you want to
adjust.
5 Press 4 or _ to make the appropriate
adjustments.
5O
Note: The screen is disrupted momentarily
when adjusting the PC settings. This is not a
sign of malfunction.
! i!ii i !i! i i i i iiiiiii!iiiii !i i i! !!! ii ii ii i i ii !i ;ii
Moves the picture left/right.
Horizontal
Position The adjustment range is within _+50from
center.*
Moves the picture upMown.
Vertical The adjustment range is within _+ 10 from
Position
center.'i_
Helps to reduce noise and sharpen the
Clock picture.
Phase The adjustment range is within _+16from
center.'i_
Helps to reduce noise and minimize
Sampling periodic vertical stripes on the screen.
Clock The adjustment range is within _+10from
centel: 'i_
Auto Highlight this item then press @
Adjust to get an optimum adjustment
automatically.
* The default settings may vary depending on
the input signal format.
Setting the PC Audio
This function allows you to output or mute the sound
from your PC when connecting using the PC IN
terminal and an analog RGB cable. (_:_ page 18)
To set the PC Audio:
MENU
Press O and open the Sound menu.
Highlight Audio Setup and press @.
Press A or V to select PC _ndi0 and then press
or _ to select N0 or Yes.
Yes: When viewing the PC input, the audio from
the PC Audio input can be heard.
_0: When viewing the PC input, there will be no
audio.
Note: Because the PC and HDMI- 7 inputs
share the same set of analog audio inputs,
the PC Audio menu setting influences the
HDMI 1 Audio menu setting. If PC Audio
(co;;_i;;_wd)
_0_46 55G300U EN-ASindb 50 2010/3/16 T@ 05:44:08