Emerson Rosemount 1057 Quick Start Manual page 13

Single channel transmitter

Hide thumbs Also See for Rosemount 1057:

September 2018

NO4

COM4

NC4

3.3.4

Wire sensor to transmitter

Procedure

1. Wire the correct sensor leads to the main board using the lead

locations marked directly on the board.

2. After wiring the sensor leads, carefully slide the wired board fully into

the enclosure slot and take up the excess sensor cable through the

cable gland.

For recommended wire entry points, see

Quick Start Guide

Relay 4

Figure

3-1.

Quick Start Guide

Table of Contents