Table of Contents
Advertisement
Suspend Timeout:
Standby CPU Speed:
Fixed Disk Timeout:
Standby Timer Reset
Events
Keyboard:
Mouse:
Standby Break Events
IRQ0-15:
40 Using the BIOS Setup Utility
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
3 hours
4 hours
This field enables and sets the inactivity duration required to elapse before
the system is placed into Suspend Mode from Standby Mode, or it disables
the Suspend Timeout. The values are the same as for the Standby Timeout,
listed above. The default is Disabled.
This field enables or disables the changing of the CPU speed based upon the
current power management state. The possible values are:
Disabled
LOW
MEDIUM
HIGH
MAX (default)
This field enables and sets the inactivity duration of fixed disk accesses
required to elapse before the system shuts off the disk drive, or it disables
the Fixed Disk Timeout. The possible values are: Disabled (default), or
1, 2, 3, 4, 5, 10, or 16 minutes.
CRT:
This field enables or disables power management of the CRT during system
entry or exit into or from Standby Mode. The possible values are: OFF in
Standby and ON in Standby. The default is ON.
This group of fields enables or disables whether or not activity from the
specified device causes the Standby Timer to be reset or not. The default is
Enabled.
This field enables or disables keyboard activity to reset the Standby
Timer or not. The possible values are: Enabled (default) and
Disabled.
This field enables or disables mouse activity to reset the Standby Timer
or not. The possible values are:
Disabled
PS/2 (IRQ12) (default)
COM1 (IRQ4)
COM2 (IRQ3)
This group of fields enables or disables a Standby Break Event for the
specified IRQ. A Standby Break Event allows the system to run at full speed
for the duration of the specified IRQ. Note that no such event is associated
with IRQ2.
Each of these fields enables or disables the Standby Break Event for each
IRQ. The possible values are: Disabled and Auto. The default setting
for IRQ 1, 3, 4, and 12 is Auto. The default setting for all other IRQs is
Disabled.
Chapter 3
Advertisement
Table of Contents
