Integrated Peripherals Sub-Menu; Figure 3-8. Integrated Peripherals Sub-Menu - HP VXI Pentium Series Hardware Installation And Configuration Manual

Integrated
Peripherals
Sub-Menu
COM port:
LPT port:
LPT Mode:
Diskette Controller:
Local Bus IDE adapter:
36 Using the BIOS Setup Utility
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This sub-menu is used to configure the onboard serial (COM) and parallel
(LPT) ports, as well as the onboard disk controllers. The Integrated
Peripherals Sub-Menu is shown below.
PhoenixBIOS Setup - Copyright 1985-95 Phoenix Technologies Ltd.
Advanced
Integrated Peripherals
COM port:
LPT port:
LPT Mode:
Diskette controller:
Local Bus IDE adapter:
↑ ↓ Select Item
F1 Help
← → Select Menu
ESC Exit

Figure 3-8. Integrated Peripherals Sub-Menu

This field configures the serial port labeled "COM1" on the front panel. The
defaults for this COM port are I/O base 3F8H and IRQ4.
This field configures the parallel port labeled "LPT" on the front panel. The
defaults for this LPT port are I/O base 378H and IRQ5.
This field sets the mode under which the LPT port operates. The selections
are:
Output only
Bi-Directional (default)
ECP
This field enables or disables the onboard 3.5-inch disk (floppy) drive
controller. The default is Enabled.
This field enables or disables the onboard PCIbus IDE hard disk controller.
The default is Enabled.
Item Specific Help
[3F8, IRQ 4] <Tab>, <Shift-Tab>, or
<Enter> selects field.
[378, IRQ 5]
[Bi-Directional]
[Enabled]
[Enabled]
-/+ Change Values F9
Enter Select > Sub-Menu F10 Previous Values
Setup Defaults
Chapter 3