Briggs & Stratton VANGUARD 810 EFI Repair Manual page 74

70
DTC P0650 Malfunction Indicator Lamp (MIL) Malfunction
Step
1. Select the Dashboard ribbon and then the Main tab.
2. Observe the Code(s) Current display.
3. Does the display indicate that a current code exists?
1
1. Disconnect MAP sensor connector, ignition coil con-
nector, or any other connector that will set a DTC. Start
2
and run engine.
2. Does the Code(s) Current display indicate that a cur-
rent code exists?
Is MIL illuminated?
3
Scan Diagnostics
Action
Figure 2-57 Check Code(s) Current Display.
Section 2: Troubleshooting DTCs
Yes
Go to step 3.
Go to step 3.
System
OK.
No
Go to step 2.
-
Go to
DTC P0650
Non-Scan
Diagnostics.