44
DTC P0132 Heated Oxygen (HO
Step
1. Disconnect and reconnect HO
and ECM J2 (Black) connectors.
2. Turn Ignition ON, Engine OFF.
1
3. Clear codes.
4. Turn Ignition OFF, and then back ON.
5. Does DTC return?
1. Turn Ignition OFF.
2. Back probe terminal C (Grey/Black wire)
of HO
sensor connector.
2
3. Connect terminal C back probe to red
meter test lead on DVOM.
4. Back probe terminal D (Brown wire) of
HO
sensor connector.
2
2
5. Connect terminal D back probe to black
meter test lead on DVOM.
6. Set DVOM to read volts DC.
7. Start and run engine for at least 2 min-
utes.
8. With engine running, observe voltage on
DVOM.
9. Is reading 600 – 950 millivolts DC?
1. Turn Ignition OFF.
2. Remove probe from terminal C, and back
probe ECM connector terminal J2-17.
3. Start and run engine.
3
4. Observe voltage on DVOM.
5. Is reading 600–950 millivolts DC?
A
B
C
C D
Figure 2-32 HO
Sensor Connector.
2
Non-Scan Diagnostics
Action
sensor
2
D
Yes
Go to step 2.
HO
sensor OK.
2
HO
sensor OK.
2
1
10
Figure 2-33 ECM J2 Connector (Black).
Section 2: Troubleshooting DTCs
) Sensor
2
Problem
corrected.
Go to step 3.
Verify that both HO
and ECM J2 connectors
are fully mated.
NOTE: If reading is above
950 millivolts DC, replace HO
sensor or identify overly rich
running condition.
9
18
J2-17
No
sensor
2
2