Table of Contents
Advertisement
■
Gloves
■
Footwear
ADDITIONAL BATTERY SAFETY WARNINGS
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your
tool, battery pack, or charger in fluid or allow a fluid to
flow inside them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals, and bleach
or bleach-containing product, etc., can cause a short
circuit.
TRANSPORTATION AND STORAGE
■
Stop the product, remove the battery pack, and allow it
to cool down before storing or transporting.
■
Clean all foreign materials from the product. Store it in
a cool, dry and well-ventilated place that is inaccessible
to children. Keep away from corrosive agents, such
as garden chemicals and de-icing salts. Do not store
outdoors.
■
Cover the saw bar with the scabbard before storing or
transporting the product.
■
When storing the product for a long period of time (one
month or longer), be sure the chain is lightly lubricated
to prevent rust.
■
For
transportation,
movement or falling to prevent injury to persons or
damage to the product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations. Follow all special requirements
on packaging and labelling when transporting batteries by
a third party.
Ensure that no batteries can come in contact with other
batteries or conductive materials while in transport by
protecting exposed connectors with insulating, non-
conductive caps or tape. Do not transport batteries that are
cracked or leaking. Check with the forwarding company for
further advice.
MAINTENANCE
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can
cause possible injury, contribute to poor performance,
and may void your warranty.
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. Have the product serviced by an authorised
service centre only. When servicing, use only original
replacement parts.
4
WARNING
secure
the
product
WARNING
WARNING
The saw chain is very sharp. To prevent personal injury,
exercise extreme caution when cleaning, fitting, or
removing the chain scabbard. Always wear protective
gloves when performing maintenance on the chain.
Improper chain maintenance increases the potential of
kickback. Failure to replace or repair damaged chain can
cause serious injury.
■
Switch off and remove the battery pack before
conducting any maintenance or cleaning work.
■
You may only make adjustments or repairs described
in this manual. For other repairs, contact the authorised
service agent.
■
Follow instructions for lubricating and chain tension
checking and adjustment.
■
After each use, clean the body and handles of the
product with a soft dry cloth.
■
Check all nuts, bolts and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
center.
MAINTENANCE SCHEDULE
against
The bar may be reversed to distribute wear for maximum
life. The bar should be cleaned every day of use and
checked for wear and damage.
Daily check
Bar lubrication
Chain tension
Chain sharpness
For damaged parts
For loose fasteners
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise during use, and
the operator should pay special attention to avoid the
following:
■
injury caused by vibration
–
Always use the right tool for the job. Use designated
handles and restrict working time and exposure.
■
injury caused by noise
–
Exposure to noise can cause hearing injury. Wear
ear protection and limit exposure.
■
injury from contact with the exposed saw teeth of the
chain
WARNING
WARNING
Before each use
Before each use and
frequently
Before each use, visual
check
Before each use
Before each use
Hide quick links:
Advertisement
Table of Contents
