as ear plugs, can limit your exposure and IMPORTANT! reduce noise. It is essential that you read the instructions ■ Wear full eye protection at all times while in this manual before assembling, operating, operating the product. Wear a full face and maintaining the product.
for one type of battery pack may create a ■ Operating similar tools nearby increases risk of fire when used with another battery both the risk of hearing injury and the pack. potential for other persons to enter your working area. ■...
■ Do not point the blower nozzle in the possible injury, can contribute to poor direction of people or pets. performance, and may void your warranty. ■ Never place objects inside the blower tubes. ■ Check all nuts, bolts, and screws before each use and at frequent intervals for ■...
Wear eye protection. Wear appropriate respiratory mask. Do not expose the product to rain or damp conditions. Guaranteed sound power level Regulatory Compliance Mark (RCM). The product meets applicable regulatory requirements. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Page 6
OBL1820S Tube latch On/Off switch Handle Blower tube High speed nozzle latch High speed nozzle Operator’s manual Battery pack Charger Know your product...
Page 7
Wear eye and ear protection, and Attach the high speed nozzle to the blower tube until it clicks into place. appropriate respiratory mask at all times while operating the product. Do not operate the product when barefoot or wearing open sandals. Install the battery pack.
Page 8
Cleaning the p.10 Using the product product p.11 Storing the product...
USING THE PRODUCT 1. Install the battery pack. Make sure that the latches on each side of the battery pack click into place. 2. Slide the on/off switch forwards to power on the product. NOTE: Always hold the product by the designated handle and let the air stream work close to the ground.
CLEANING THE PRODUCT 1. Slide the on/off switch backwards to power off the product. 2. Press the latches on each side of the battery pack, and remove it from the battery port. 3. Clean the product using a soft, dry brush. WARNING: Do not use water when cleaning the product.
STORING THE PRODUCT 1. Slide the on/off switch backwards to power off the product. 2. Press the latches on each side of the battery pack, and remove it from the battery port. 3. Press the tube latch, and remove the blower tube.
Cordless blower with a standardised test and may be used to compare Model OBL1820S one tool with another. They may be used for a preliminary assessment of exposure. Rated voltage 18 V d.c.
Page 16
Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC 3149 Melbourne, Australia Techtronic Industries N.Z. Limited Unit C, 70 Business Parade South, Highbrook, Auckland 2013, New Zealand RYOBI is a trade mark of Ryobi Limited, and is used under license. 961497030-02...
Need help?
Do you have a question about the OBL1820S and is the answer not in the manual?
Questions and answers