Table of Contents
Advertisement
SWITCH POSITION
Display
Description
REV
Reverse
1
Speed 1
2
Speed 2
NOTE: Turning off the kickback protection at any time is not
recommended. However, in the event that it is deactivated,
the product still has overload protection.
Ensure to maintain has a firm grip and solid stance when
using the product.
TRANSPORTATION AND STORAGE
■
Turn off the product, remove the battery pack, and allow
the product to cool down before storing or transporting.
■
Clean all foreign material from the product.
■
Do not store or transport the product with the battery
pack fitted. Remove the battery pack, and secure it
separately. Store the product in a cool, dry, and well-
ventilated place that is inaccessible to children. Keep
the product away from corrosive agents, such as garden
chemicals and de-icing salts. Do not store the product
outdoors.
■
For transportation in vehicles, secure the product
against movement or falling to prevent injury to persons
or damage to the product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery pack in accordance with local and
national provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps or
tape. Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
MAINTENANCE
■
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can cause
possible injury, can contribute to poor performance, and
may void your warranty.
■
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. Have the product serviced by an authorised
service centre only.
WARNING! The auger bit is very sharp. To prevent
personal injury, exercise extreme caution when cleaning,
fitting, or removing the auger bit. Always wear protective
gloves when performing maintenance on the bit.
■
Turn off the product and remove the battery pack before
conducting any maintenance or cleaning work.
■
You may make adjustments or repairs described in this
manual. For other repairs, contact an authorised service
centre.
■
After each use, clean the product with a soft, dry cloth.
Any part that is damaged should be properly repaired or
replaced by an authorised service centre.
Location
■
Check all nuts, bolts, and screws before each use and
at frequent intervals for proper tightness to ensure that
Bottom
the product is in safe working condition. Any part that is
damaged should be properly repaired or replaced by an
Middle
authorised service centre.
Top
■
Bring the product to an authorised service centre to
replace damaged or unreadable labels.
SYMBOLS ON THE PRODUCT
Safety alert
Read and understand all the
instructions before operating the
product. Follow all the warnings and
safety instructions.
Do not expose the product to rain or
damp conditions.
Wear non-slip, heavy-duty protective
gloves.
Wear non-slip safety footwear when
using the product.
Wear eye protection.
Wear ear protection.
Remove the battery pack before
starting any work on the product.
Beware of thrown or flying objects.
Keep all bystanders, especially children
and pets, at least 15 m away from the
operating area.
Keep feet and legs away from the
auger.
Never operate the auger in areas with
underground electric, gas, water, or
telephone lines.
Maintain a firm grip with both hands on
the auger during operation.
Regulatory Compliance Mark (RCM).
The product meets applicable
regulatory requirements.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.
Original Instructions
5
Advertisement
Table of Contents
