Transportation And Storage - Ryobi R36XSHR10 Manual

prolonged use of a product. When using
any product for prolonged periods, ensure
to take regular breaks.
SHREDDING GUIDE
For best results when shredding, follow the
guidelines shown in the table below.
MATERIAL SHREDDING METHOD
Feed into the feeding
Twigs up to 6 chute at a rate which
mm diameter the product will accept
without overloading.
Clip off all side growth
Branches up
with secateurs before
to 40 mm in
feeding into the feeding
diameter
chute.
Bedding plants, Knock soil and stones off
weeds, and the roots to avoid damage
shrubby growth to the blades.
By inserting these at the
end of your shredding
task, this will help to clean
Dry sticks and
the moisture and plant
twigs
sap from the inside of the
product and the cutting
assembly.
■ Do not allow garden waste to accumulate
before shredding as it will begin to compost,
become too damp, and clog the cutting
assembly. Dry material will help most
material to clear the ejection chute. Save
some dry sticks until last to help clean the
blade area.
■ Frequently monitor the build up of shredded
material.
■ The exit of the discharge chute must be
clear at all times to prevent blockages.
■ When the collection bin is full, turn off the
product before emptying.
■ Do not put your hands inside the product's
discharge chute to clear away shredded
material while the product is turned on.
The blades are sharp. Wear heavy-duty
gloves and exercise extreme caution when
cleaning and clearing blockages.
4
Original Instructions
■ When feeding long woody branches or
stems into the product, be careful of whip
and vibrations as they get caught by
the cutter. The operator must wear eye
protection whenever using the product.
■ The cutting device has a tendency to pull
branches or stems into the product. Do not
try to impede the entry of the material being
cut once feeding has started. Always wear
gloves to prevent skin lacerations when
feeding material into the product.
NOTE: While setting up the product for use,
make sure that the product is secured so that it
does not tip over.
In normal use, do not turn off the product until
all of the shredded material has cleared the
cutter assembly. If the product is turned off too
quickly, remaining pieces of material may clog
the blade assembly and stall the motor when
the product is turned back on.

TRANSPORTATION AND STORAGE

■ Make sure that the product has been
thoroughly cleaned before storing it in a
clean, dry place and secured out of the
reach of children.
■ Allow the product to adequately cool down
before storing or transporting.
■ When transporting the product in a vehicle,
secure it against movement or falling to
prevent injury to persons or damage to the
product.
ADDITIONAL BATTERY SAFETY
WARNINGS
■ To reduce the risk of fire, personal injury,
and product damage due to a short circuit,
never immerse the product, battery pack, or
charger in fluid or allow fluid to flow inside
them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals,
and bleach or bleach-containing products,
etc., can cause a short circuit.
■ Charge the battery pack in a location where
the ambient temperature is between 10°C
and 38°C.
■ Store the battery pack in a location where
ambient temperature is between 0°C and
40°C.
■ Use the battery pack in a location where the
ambient temperature is between 0°C and
40°C.