On/Off Signal; On/Off Signal Setting - Samwontech TEMP2000 Series Installation Manual

SAMWONTECH
8. ON/OFF 시그널
▶ This screen can set the range of ON/OFF Signal, High & Low Limit Deviation.
▶ 6 ON / OFF signals can be set.
▶ [5.1.3 Relay Setup Screen-3] can set Relay Number and Delay Time.

8.1 ON/OFF Signal Setting

① Set CH1 Low Limit SP for ON/OFF Signal Operation.
② Set CH1 Middle SP for ON/OFF Signal Operation.
③ Set CH1 High Limit SP for ON/OFF Signal Operation.
④ Set Operating Point at High Limit Section.
⑤ Set Operating Point at Low Limit Section.
Table 8-1 CH1 ON/OFF Signal Setup Parameter
Parameter
T#n LOW SP
T#n MIDDLE SP
T#n HIGH SP
T#n HIGH 편차
T#n LOW 편차
* #n : 1 ~ 6
2nd Edition of TEMP2000_Series IM : July. 16. 2010
①
[Figure 8-1] ON/OFF Signal Setup Screen
Range
EU(0.0~100.0%)
Range Low ≤ T#n LOW SP
<T#n MIDDLE SP < T#n HIGH SP ≤ Range High
EUS(0.0~10.0%)
EUS(0.0~10.0%)
② ③ ④ ⑤
Unit
EU
EU
EU
EUS EUS(0.0%)
EUS EUS(0.0%)
Default
EU(0.0%)
EU(0.0%)
EU(0.0%)
Page 58 / 87