Samwontech TEMP2000 Series Installation Manual page 52

SAMWONTECH
Table 5-6 Aux. Relay Setup Screen-2, 3 Parameter
Parameter
Up Signal Relay
Up Signal Deviation
Soak Signal Relay
Signal Keep Time
Down Signal Relay
Down Signal Deviation
1st Freezer Run Signal Relay
1st Freezer Run Signal
Delay Time
2nd Freezer Run Signal Relay
2nd Freezer Run Signal
Delay Time
Error Signal Relay
Error Signal Keep Time
User Button Relay
* RELAY Number 13~32 can be used when I/O2 BOARD option is added.
* After passing defined 2.REF DELAY TIME from starting 1.REF SIGNAL, 2.REF SIGNAL will be ON.
Table 5-7 Relay ON Time Definition for each Signal
Signal
When delete the message by screen touch after
preset Relay On Time after error occurred.
End Signal
When delete the message by screen touch
during Relay On Time after error occurred.
Error Signal,
When recover after preset Relay On Time
Sensor Open
Signal, Wait
When recover during preset Relay On Time
Signal
2nd Edition of TEMP2000_Series IM : July. 16. 2010
Range
0~32
EUS(0.0~10.0%)
0~32
0.00~99.59 (MIN.SEC)
0~32
EUS(0.0~10.0%)
0~32
0.00~99.59 (MIN.SEC)
0~32
0.00~99.59 (MIN.SEC)
0~32
0.00~99.59 (MIN.SEC)
0~32
Condition
Unit Default
ABS
EUS EUS(0.0%)
ABS
EUS 00.00
ABS
EUS EUS(0.0%)
ABS
ABS 00.00
ABS
ABS 00.00
ABS
ABS 00.00
ABS
Relay ON Time
ON until preset Relay On Time
ON until screen touch time
ON until recover time
ON until preset Relay On Time
Page 49 / 87
0
0
0
0
0
0
0