Table of Contents
Advertisement
Setting Up the Software for Data Calls
3
Select IShow Installed Software I and press
<Enter>.
You see a list of software packages installed
on your system, similar to this list:
1;"jlMII'IU:IUU-'"
4
Look for AT&T TELEPHONE 3.5.
The Telephone
Manager software must be installed before you
can install the ATE software.
If AT&T
TELEPHONE 3.5 is listed, the Telephone
Manager software is already installed.
If it
is not yet installed, refer to the AT&T UNIX
PC Telephone Manager User's Guide for
installation procedures.
5
Next, look for ATE 3.5.
If it is listed, the
ATE software is already installed.
You can
skip the installation procedures.
If you
want to install a new version, refer to the
Managing the UNIX PC section of the AT&T UNIX
PC Owner's Manual for information on how to
remove the old version.
If ATE 3.5 is not
listed, use the following procedures to
install it.
Installing ATE Software
To install the ATE software:
3-2
1
Select I Administration I from the Office and
press <Enter>.
2
Select ISoftware Setup I from the
Administration menu and press <Enter>.
Advertisement
Table of Contents
