Table of Contents
Advertisement
2.35 TSK
Automotive-lift date: 01/2010
Manual date: 01.01.10
Operating instruction and Documentation
Serial number:..........................................
Händleradresse/Telefon
Made in Germany
Otto Nußbaum GmbH & Co.KG//Korker Straße 24//D-77694 Kehl-Bodersweier
Tel: +49(0)7853/8990 Fax: +49 (0) 78 53 / 87 87
E-mail: info@nussbaum-lifts.de//http://www.nussbaum-lifts.de
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Nussbaum 2.35 TSK
Summary of Contents for Nussbaum 2.35 TSK
- Page 1 2.35 TSK Automotive-lift date: 01/2010 Manual date: 01.01.10 Operating instruction and Documentation Serial number:.......... Händleradresse/Telefon Made in Germany Otto Nußbaum GmbH & Co.KG//Korker Straße 24//D-77694 Kehl-Bodersweier Tel: +49(0)7853/8990 Fax: +49 (0) 78 53 / 87 87 E-mail: info@nussbaum-lifts.de//http://www.nussbaum-lifts.de...
-
Page 2: Table Of Contents
Operating Instruction and Documentation 2.35 TSK Content Foreword ......................... 3 Record of installation ....................5 Record of handing over ................... 6 1.Introduction......................7 1.1 Installation and check of the automotive lift ............7 1.2 Information of Warning ..................7 2.Master document of the automotive lift ..............8 2.1 Lift –manufacturer.................... -
Page 3: Foreword
Operating Instruction and Documentation 2.35 TSK Foreword Nussbaum-Lifts are a result of long-standing experiences. The high quality and the superior concept guarantee them reliability, a long lift time and the economic business. To avoid unnecessary damages and dangers, read the operating instruction attentive and observe the contents. - Page 4 Operating Instruction and Documentation 2.35 TSK Organising requirements The instructions for use are constantly to be kept at the place of operation being at hand at any time. In addition to the instructions for use rules pertaining to other regulations i.e. accident prevention and environmental rules are to be observed and directed.
-
Page 5: Record Of Installation
Operating Instruction and Documentation 2.35 TSK Filling out and undersigned and copying this sheet and send the original to the lift manufacturer. The copy remains in the Manual. Otto Nußbaum GmbH & Co.KG Korker Strasse 24 77694 Kehl-Bodersweier Germany Record of installation The automotive lift with the Serial number:.......... -
Page 6: Record Of Handing Over
Operating Instruction and Documentation 2.35 TSK Record of handing over The automotive lift with the Serial number:..........was installed on:..........at the firm:..........at:..............the safety was checked and the lift was started. The persons below were introduced after the installation of the automotive lift. The introduction was carried out from an erector of the lift-manufacturer or from a franchised dealer (competent person). -
Page 7: Introduction
Operating Instruction and Documentation 2.35 TSK 1.Introduction The document ”Operating Instructions and Documentation” contains important information about installation, operation and maintenance of the automotive lift. To furnish proof of installation of the automotive lift the form ”Record of Installation” must be signed and returned to the manufacturer. -
Page 8: Master Document Of The Automotive Lift
D-77694 Kehl-Bodersweier 2.2 Application The automotive lift 2.35 TSK is a lifting mechanism for lifting motor vehicles with a laden weight of up to 3500 kg. The max. load distribution is 2:1 in or against drive-on direction. The automotive lift is only designed for servicing vehicles. It is not allowed to carry persons with the lift. -
Page 9: Declaration Of Conformity
Operating Instruction and Documentation 2.35 TSK 2.5 Declaration of conformity - 9 -... -
Page 10: Technical Information
Operating Instruction and Documentation 2.35 TSK 3.Technical Information 3.1 Technical ratings Capacity: 3500 kg Load distribution: max. 2:1 in or against the drive on direction Lifting time: approx. 25 sec. with load Lowering time: approx. 30 sec. with load Lifting height:... -
Page 11: Data Sheet
Operating Instruction and Documentation 2.35 TSK 3.3 Data sheet - 11 -... -
Page 12: Foundation Diagram Drawing
Operating Instruction and Documentation 2.35 TSK 3.4 Foundation diagram drawing - 12 -... -
Page 13: Hydraulic Diagram Drawing
Operating Instruction and Documentation 2.35 TSK 3.5 Hydraulic diagram drawing - 13 -... -
Page 14: Electrical Diagram Drawing
Operating Instruction and Documentation 2.35 TSK 3.6 Electrical diagram drawing - 14 -... - Page 15 Operating Instruction and Documentation 2.35 TSK - 15 -...
- Page 16 Operating Instruction and Documentation 2.35 TSK - 16 -...
- Page 17 Operating Instruction and Documentation 2.35 TSK - 17 -...
-
Page 18: Safety Regulations
Operating Instruction and Documentation 2.35 TSK 4. Safety regulations When using automotive lifts the German safety regulation BGG945: Examine of automotive-lifts; BGR500 Using automotive-lifts; (VBG14) must be observe adhered to. Especially the following regulations are very important: • Observe the detailed operating instruction. -
Page 19: Lowering The Vehicle
Operating Instruction and Documentation 2.35 TSK • Press the button „ Lifting“. • Check the safety device of the lifting arms. They must lock if the arms leave the floor. • If the wheels are free, stop the lifting procedure and check again the safety position of the vehicle. -
Page 20: Driving On An Obstacle
Operating Instruction and Documentation 2.35 TSK Problem: Motor starts, lift does not lift! Potential causes: solution: The vehicle is too heavy unload the vehicle Level of the oil is too low check the oil level, fill with hydraulic oil as required... -
Page 21: Inspection And Maintenance
Operating Instruction and Documentation 2.35 TSK Be careful: Unroll the sheathed cable for lowering with its whole length and go outside of the emergency area. • Remove the cover of the canister. • Position an obstacle (piece of wood max. 5mm) between the cover and the canister so the emergency cable can be moved easily. -
Page 22: How Often Must The Lift Be Cleaned
Operating Instruction and Documentation 2.35 TSK Use an ATF-Suffix hydraulic-oil (OEST Company ) if the ambient temperature is under 5 degrees centigrade. After filling, the hydraulic oil must be between the upper and lower markings of the oil level gauge. -
Page 23: Security Check
Operating Instruction and Documentation 2.35 TSK Obviously this is dependent on the type of work being done with the lift, the degree of cleanliness of the workshop and location of the lift. The degree and amount of dirt is dependent on the season, on the weather conditions and the ventilation of the workshop. -
Page 24: Installation And Initiation
Operating Instruction and Documentation 2.35 TSK 9.Installation and Initiation 9.1 Regulations for the installation • The installation of the lift is performed by trained technicians of the manufacturer or its distribution partner. If the operator can provide trained mechanics, he can install the lift by himself. -
Page 25: Initiation
Operating Instruction and Documentation 2.35 TSK 3. Fill tank with a high quality oil. (Litre and cst. => see chapter 3.1) C. Test-run 1 . Run the lift a few times (60 cm) up (2') and down without load. Bleed the hydraulic cylinder. -
Page 26: First Security Check Before Installation
Operating Instruction and Documentation 2.35 TSK 9.4 First security check before installation Filling out and leave in this manual Serial-number:______________________ defect veri- kind of check right missing fication remark ---------------------------------------------------------------------------------------------------------------------------------------- Type plate......................Short operating instruction................... Warning designation.................... -
Page 27: Regular Security Check And Maintenance
Operating Instruction and Documentation 2.35 TSK 9.5 Regular security check and maintenance Filling out and leave in this manual Serialnumber:______________________ defect veri- kind of check right missing fication remark ---------------------------------------------------------------------------------------------------------------------------------------- Type plate......................Short operating instruction................... Warning designation.................... - Page 28 Operating Instruction and Documentation 2.35 TSK Regular security check and maintenance Filling out and leave in this manual Serial-number:______________________ defect veri- kind of check right missing fication remark ---------------------------------------------------------------------------------------------------------------------------------------- Type plate......................Short operating instruction................... Warning designation.................... Designation lifting/lowering......…..
- Page 29 Operating Instruction and Documentation 2.35 TSK Regular security check and maintenance Filling out and leave in this manual Serial-number:______________________ defect veri- kind of check right missing fication remark ---------------------------------------------------------------------------------------------------------------------------------------- Type plate......................Short operating instruction................... Warning designation.................... Designation lifting/lowering......…..
- Page 30 Operating Instruction and Documentation 2.35 TSK Regular security check and maintenance Filling out and leave in this manual Serial-number:______________________ defect veri- kind of check right missing fication remark ---------------------------------------------------------------------------------------------------------------------------------------- Type plate......................Short operating instruction................... Warning designation.................... Designation lifting/lowering......…..
- Page 31 Operating Instruction and Documentation 2.35 TSK Regular security check and maintenance Filling out and leave in this manual Serial-number:______________________ defect veri- kind of check right missing fication remark ---------------------------------------------------------------------------------------------------------------------------------------- Type plate......................Short operating instruction................... Warning designation.................... Designation lifting/lowering......…..
- Page 32 Operating Instruction and Documentation 2.35 TSK Regular security check and maintenance Filling out and leave in this manual Serial-number:______________________ defect veri- kind of check right missing fication remark ---------------------------------------------------------------------------------------------------------------------------------------- Type plate......................Short operating instruction................... Warning designation.................... Designation lifting/lowering......…..
-
Page 33: Extraordinary Security Check And Maintenance
Operating Instruction and Documentation 2.35 TSK 9.7 Extraordinary security check and maintenance Filling out and leave in this manual Serial-number:______________________ defect veri- kind of check right missing fication remark ---------------------------------------------------------------------------------------------------------------------------------------- Type plate......................Short operating instruction................... Warning designation.................... -
Page 34: Required Screws For Nußbaum-Top-Lifts
Operating Instruction and Documentation 2.35 TSK 9.8 Required Screws for Nußbaum-Top-Lifts Type Screws Strength of Lock washer Piece/stam extension 1.25 SH M20x90* M 20 7980 1.35 SH M24x90* „ „ M 24 „ „ M20x90* 2.35 TTS M16x60* „ „... - Page 35 Operating Instruction and Documentation 2.35 TSK Use the right screw to tighten the carrying supports on the lifting-stamps. Otherwise a malfunction can lead it to damages or lead to danger for body and lives. Observe, the screws must be tighten with the described torque.
Need help?
Do you have a question about the 2.35 TSK and is the answer not in the manual?
Questions and answers