Configuring Ntp Server - HIKVISION ERT-F204 Series User Manual

ERT-F2xxx DVR User Manual
2) In the DVR Domain Name text field, enter the domain obtained from the NO-IP Web site
(www.no-ip.com).
3) Enter the User Name and Password registered in the NO-IP Web site.
Click Apply to save the settings.
After setting all the required parameters for the DDNS, you can view the connecting status of the device by
checking the Status information.

Configuring NTP Server

Purpose:
Ensure the network connection of the PC (running the FTP server) and the device is valid and correct. Run the
FTP server on the PC and copy the firmware into the corresponding directory of your PC.
Refer to the FTP server user manual to set the FTP server on your PC and put the firmware file into
the directory as required.
Go to Menu > Configuration > Network.
Select NTP to enter the NTP Settings interface, as shown in Figure 9-9.
Check Enable NTP to enable this feature.
Configure the following NTP settings:
Interval: Time interval between the two synchronizing actions with NTP server. The unit is minute.
•
NTP Server: IP address of NTP server.
•
UM ERT-F2xxx 030118NA
Figure 1. 1 NO-IP Settings Interface
NTP Settings Interface
102