Connecting Dc Power - Avaya Virtual Services Platform 7000 Series Installation Manual

You must prepare the cables by stripping insulation from the end of the cable approximately
0.81 inch (2.1 cm) before you fasten each cable to a power supply terminal. The following
figure shows the DC power supply terminals and DC power supply status LEDs.
Figure 6: DC power supply terminals

Connecting DC power

Perform the following procedure to connect a DC power source to the switch.
Before you begin
Ensure the DC power source is switched off. Ensure the switch power supply supports DC
power input.
Ensure the cables ends are stripped and that the cables are an appropriate length and gauge
for the installation.
VSP 7000 installation
Power connections
April 2012 21