Hydraulic Motor Coupling; Engine; Approved Fuel; Engine Oil - Meridian Seed Express 275 DX Operator's Manual

Bulk seed tender
Table of Contents

Advertisement

10.2.3 Hydraulic Motor Coupling

Changing the pump coupling does not require the
hydraulic tank to be drained. If the pump must
be disconnected, drain the hydraulic tank and be
prepared to catch any oil that remains in the two
hydraulic hoses.
1. Remove the orange protective cover from the
adapter assembly.
2. Remove the two pump mounting bolts.
3. Pull the pump away from the adapter to
separate the coupling halves.
4. Loosen the setscrews in each coupling half
and remove the old couplings.
46
5. Install new couplings on the engine shaft and
the pump shaft. When completely assembled,
the shaft length in each coupling half should
be the same. Tighten the pump end setscrews
to 78 to 87 lb-in. Do not tighten the engine
shaft coupling at this time.
6. Place the urethane spider in the pump
coupling. Align and install the pump and pump
coupling.
7. Tighten the pump bolts to a "Grade 5" bolt
toque for that size of bolt. Refer to the 4.2 Bolt
Specifications section.
8. Slide the engine coupling against the other
coupling half and tighten the setscrew.
9. Replace the orange protective cover.
NOTE: If the adapter plate was removed, tighten
the four retaining bolts to "Grade 5" bolt torque for
that size of bolt.

10.3 ENGINE

For any questions concerning the Honda
not provided in this manual, refer to the OEM
manual that was provided with the seed tender.
To contact Honda
, refer to the OEM Literature
®
section in this manual.

10.3.1 Approved Fuel

Use a regular unleaded automotive gasoline for all
operating conditions. The fuel tank capacity is 1.0
liter (2.1 US pints).

10.3.2 Engine Oil

Use a typical SAE 10W-30 or 10W-40 multi-
viscosity motor oil for normal operating conditions.
Consult your engine manual for the recommended
oil in cold temperatures. The crankcase capacity
is 1.1 liters (1.16 US qt.).

10.3.3 Change Engine Oil

1. Review the Operator's Manual for the engine.
2. Allow the engine to cool before changing oil.
Draining works best when oil is warm.
CAUTION
Burn Hazard. Hot engine oil can burn
skin.
3. Be sure the engine key switch is in the OFF
position and the fuel valve is turned OFF.
engine
®

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Seed express 375 dx400 sldSeed express 375

Table of Contents