Storage; General Information; Placing In Storage; Removing From Storage - Meridian Seed Express 275 DX Operator's Manual

8. STORAGE

8.1 GENERAL INFORMATION

After planting or when the machine will not be
used for a period of time, completely inspect
all major systems of the seed tender. Replace
or repair any worn or damaged components to
prevent unnecessary downtime at the beginning of
the next season.
IMPORTANT
To prevent component damage, store the seed
tender in a dry, level area. If the seed tender is not
attached to a trailer, support the frame with planks
to raise the unit off the ground.

8.2 PLACING IN STORAGE

CAUTION
Store the unit in an area away from
human activity. To prevent the possibility
of serious injury, do not permit children
to play on or around the stored machine.
1. Remove all seed from the seed tender.
2. Place the gasoline engine fuel valve in the
OFF position.
3. Thoroughly wash the machine with a pressure
washer or water hose to remove all dirt, mud,
or debris.
4. Inspect rotating parts for entangled material.
Remove all entangled materials.
5. Check the condition of the conveyor belt.
Replace or adjust, as required.
6. Check the condition of the hydraulic pump to
engine shaft connectors and spider. Replace
or adjust, as required.
7. Touch up paint nicks and scratches to prevent
rusting.
8. Remove the ignition key and store in a secure
place.
9. Remove the battery and store it in a cool, dry
area on wooden blocks or a wooden pallet.
Charge it monthly to maintain an adequate
charge.
10. It is best to store the machine inside and if that
is not possible, cover with a waterproof tarp
and tie down securely.
42

8.3 REMOVING FROM STORAGE

When removing the machine from storage, follow
this procedure:
1. Remove the tarp, if covered.
2. Install and connect the battery.
3. Review and follow the Pre-Operation
Checklist.
4. Review and follow the Service Checks in the
Maintenance section.
IMPORTANT
If the machine has been stored for more than
twelve months, warm the engine by running it for
two to three minutes and drain the oil. Change
the oil while the oil is warm to remove any
condensation. Refer to the Engine Oil Change in
the Maintenance section.