Engine And Controls - Meridian Seed Express 275 DX Operator's Manual

5.2 ENGINE AND CONTROLS

A Honda engine is used with the unit. Always
®
read the engine Operator's Manual supplied
with the seed tender for the detailed operating
procedures.
1. Electrical System Key Switch (located in
Control Box 7)
This key switch controls the power to the
electrical system. Turn the key clockwise to turn
the electrical system ON. The key must be in
the ON position for the engine to start. Turn the
key counterclockwise to stop the engine and
turn OFF the electrical system.
2. Engine Start Button (located in
Control Box 7)
Press and hold this button until the engine
starts. Also set the choke lever on the engine
when starting the engine. Turn the key switch
counterclockwise to turn OFF the engine.
3. Fuel Shut-Off Valve
Each engine is equipped with a valve between
the fuel tank and the carburetor. Slide the fuel
valve toward the block to turn ON and away
for OFF. Turn the fuel OFF when not in use or
before transporting.
4. Throttle Lever
This lever controls the engine RPM. Move
the lever laterally to increase or decrease the
RPM. Always run at maximum throttle while
operating.
5. Choke Lever
The choke lever controls the fuel/air mixture to
the engine. Close the choke when starting if the
engine is cold. Open the choke as the engine
warms. Always open the choke fully during
operation.
6. Starting Rope
This retracting rope and T-bar is an optional
method used to turn the engine over for
starting. Grasp the T‑bar firmly and pull the
rope sharply to start the engine. Key on master
control must be ON to pull-start.
7. Battery (12 Volt)
A 12 Volt battery supplies the power to start the
gasoline engine. When the engine is operating
a trickle charge is sent to the battery to keep it
fully charged.
25