Expanding/Replacing The Main Memory - Fujitsu PRIMERGY TX150 S6 Options Manual

Expanding/replacing the main memory

The following table shows the prescribed equipping order:
single channel
single/dual
1
channel
dual channel
1
The dual-channel mode is only activated, if the size of the used memory modules in socket
DIMM 2A is equal to the summary of memory modules in sockets DIMM 1A and DIMM 1B
(e.g. DIMM 1A = 512 MB, DIMM 1 B= 512 MB, DIMM 2A = 1 GB).
I
In case of dual channel configuration with four memory modules: all four
memory slots must be equipped with identical memory modules.
5.2 Expanding/replacing the main memory
Ê Open the server as described in the
seq..
1
Figure 13: Removing a memory module
Ê Fold the assembly brackets outwards on both sides of the corresponding slot
(1).
Ê If the slot was equipped: pull the memory module out of the slot (2).
30
DIMM 1A DIMM 2A
equipped empty
equipped equipped
equipped empty
equipped equipped
Options Guide
DIMM 1B
empty
equipped
equipped
equipped
chapter "Preparation" on page 21
2
Main memory
DIMM 2B
empty
empty
empty
equipped
et
1
TX150 S6