Floorstand model
Preparation
4.1.2
Removing the front cover
Remove the front cover when making the following extensions and upgrades:
– Installation of further accessible drives
– Conversion from a floorstand model to a rack model
Ê Remove the hard disk cover as shown in
figure 6 on page
24.
1
2
4
3
Figure 3: Removing the front cover
Ê Disengage the three tabs (1-3) on the left side one after the other and rotate
the front cover outward (4) about 2 cm.
2
1
Figure 4: Loosening the upper hook
Ê Push the drive cover downward (1).
Ê Press the touch point of the upper hook (2) inward.
22
Options Guide
TX150 S6