Fujitsu PRIMERGY TX150 S6 Options Manual page 38

Installing a 3.5-inch floppy disk drive
Figure 22: Installing the floppy disk drive in the drive holder
Ê Position the new floppy disk drive in the drive holder (1) and fasten it with two
screws on each side (2).
Figure 23: Mounting the floppy disk drive holder
Ê Push the drive holder and floppy disk drive fully into the mounting bay (1).
Ê Fasten the drive holder to the housing with two screws (2).
Ê Connect the data cable to the floppy disk drive (see the cabling plans in the
Appendix).
Ê Connect the power cable to the floppy disk drive (see the cabling plans in the
Appendix).
Ê Attach the front cover or rack front cover, close the server, connect it to the
power outlet, and switch it on as described in the
page 85 et seq..
38
1
2
Options Guide
Accessible drives
2
1
2
chapter "Completion" on
TX150 S6