Procedure - Fujitsu PRIMERGY TX150 S6 Options Manual

2

Procedure

V
CAUTION!
● The actions described in this manual should only be performed by
technical specialists.
Repairs to the device that do not relate to CSS failures must only be
●
carried out by service personnel. Please note that unauthorized inter-
ference with the system will void the warranty and exempt the
manufacturer from all liability.
Any failure to observe the guidelines in this manual, and any improper
●
repairs could expose the user to risks (electric shock, energy
hazards, fire hazards) or damage the equipment.
Ê First of all, carefully read the safety instructions in the
instructions" on page 15
Ê Make sure that all necessary manuals (see the
overview" on page
importantly, you will need the operating manual for the server and the
technical manual for the system board.
Ê Shut the server down correctly, switch it off, disconnect the power plugs and
open the server as described in the
seq..
Ê Carry out the expansion or upgrade of your server as described in the
pertinent chapter.
I
Installation and removal of the hot-plug components are described in
the operating manual.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 85
Ê Start the operating system and make the appropriate configuration if
necessary (see the operating manual).
TX150 S6
et seq..
7) are available; print the PDF files if required. Most
chapter "Preparation" on page 21
Options Guide
chapter "Safety
section "Documentation
et seq..
et
13