32X32 Digital Video Matrix Card Installation - PESA Cougar Manual

Digital Video
2.11 PS70V Power Supply Installation Continued:

2.12 32X32 Digital Video Matrix Card Installation

2
INSTALLATION
page 2.10
Installation
2. Carefully push the power supply into the switcher until the power
supply connector makes initial contact with backplane power connec-
tor. At this point, firmly but carefully continue pushing the power supply
into the switcher while making sure the connectors are properly aligned
and that no connector pins are being bent. Continue pushing the
power supply until it is in place and the connectors are firmly mated.
3. Align the secondary (redundant) power supply with the right-hand set
of circuit card guides in the upper right-hand side of the Cougar Digital
Video Routing Switcher.
4. Repeat step two.
5. If the Cougar Digital Video Routing Switcher is being shipped, install
the two power supply retainer screws through the top of the Cougar
Digital Video Routing Switcher.
The 32X32 Digital Video Matrix Card is installed in the lower portion of the
Cougar Digital Video Routing Switcher. To install the matrix board in the
Cougar Digital Video Routing Switcher take the following steps while
referring to the Cougar Digital Video Mainframe configuration drawing on
page 6.2:
1. Align the shield plate of the matrix card with the set of circuit card
guides in the lower portion of the Cougar Digital Video Routing
Switcher.
2. Carefully push the matrix board into the switcher until the circuit card
connectors make initial contact with backplane connectors. At this
point, firmly but carefully continue pushing the matrix card into the
switcher while making sure the connectors are properly aligned and
that no connector pins are being bent. Continue pushing the card until
it is in place and the connectors are firmly mated.
Section 2
10/95
P/N 81905903440