Table of Contents
Advertisement
Power Supply Installation
The Power Supplies are located as shown in Figure 25 and are installed as follows:
1. Align the left side-plate of the Power Supply with the card guides in the chassis.
2. Carefully insert the Power Supply into the chassis until the connectors on the Power Supply
make contact with the midplane connectors. Inspect the mating connectors, if possible, to
ensure proper alignment.
3. Firmly push the Power Supply into the chassis until the connectors on the Power Supply are
fully mated with the midplane connectors.
4. Tighten the two captive retaining screws until secure.
5. Repeat the above steps for the other Power Supply.
48x16 Matrix Board Installation
The 48x16 Matrix boards are located as shown in Figure 25 and are installed as follows:
1. Align the printed circuit board of the 48x16 Matrix board with the card guides in the chassis.
2. Carefully insert the 48x16 Matrix board into the chassis until the connectors on the 48x16
Matrix board make contact with the midplane connectors. Inspect the mating connectors, if
possible, to ensure proper alignment.
3. Firmly push the 48x16 Matrix board into the chassis until the connectors on the 48x16 Matrix
board are fully mated with the midplane connectors.
4. Repeat the above steps for each additional 48x16 Matrix board.
System Controller Installation
The System Controllers are located as shown in Figure 25 and are installed as follows:
1. Align the support plate of the System Controller with the card guides in the chassis.
2. Carefully insert the System Controller into the chassis until the connectors on the System
Controller make contact with the midplane connectors. Inspect the mating connectors, if
possible, to ensure proper alignment.
3. Firmly push the System Controller into the chassis until the connectors on the System
Controller are fully mated with the midplane connectors.
4. Repeat the above steps for the other System Controller.
36
Tiger Video Routing Switcher
This equipment contains two power supply assemblies
connected in parallel. Only one power supply assembly is
required to power this equipment. The second power supply
assembly serves as a backup for the first. One power supply
assembly may safely be removed while the other power supply
assembly is connected to the power source.
NOTE
Chapter 2 – Installation
Advertisement
Table of Contents
