Cabling; Figure 2-1 Chassis Installation - PESA Cougar Manual

Digital Video
2.5 Mounting Continued:

2.6 Cabling

Considerable weight will be added to the rear panel of the Cougar Digital
Video Routing Switcher by the control, signal, and power cables. There-
fore, all cables should be strained relieved and secured to racks or other
supporting structures. Failure to provide adequate cable support can result
in cables separating from connectors. If cable runs are to be stored under
an elevated floor, they should be tied to the racks as a guide. If cables are
run along the floor, do not allow them to lay in the work area behind the
racks. Stepping or tripping on the cables may result in connections being
pulled free or wire breakage inside the insulation. The Cougar Digital
Video Routing Switcher should be installed in the equipment rack prior to
attaching cables.
Use the following rules when cabling the Cougar Digital Video Routing
Switcher:
1. Lay all cables in their intended positions, separating control, video, and
power cables wherever possible.
2. Provide proper support for each cable during the cabling process. The
use of tie-wraps is recommended as shown in Figure 2-2.
10/95
P/N 81905903440
Installation

Figure 2-1 Chassis Installation

Section 2
2
INSTALLATION
page 2.3