How To Use - Hitachi WM 10DBL Handling Instructions Manual

(1) Pull the guide sleeve back.
(2) Insert the bit into the hexagonal hole in the anvil.
(3) Release the guide sleeve and it returns to its original
position.
CAUTION:
If the guide sleeve does not return to its original position,
then the bit is not installed properly.
○ Drill bit
• A drill with hexagonal shank can be attached directly to
the tool.
• To attach a drill without hexagonal shank, you need to
have the drill chuck adapter set sold separately.
(1) Insert the drill bit into the chuck.
(2) Use the chuck key to secure the drill bit, tightening the
chuck by each of the three holes in turn. (Fig. 5)
• Use an iron drill to make a pilot hole for a wood screw or
a 10 mm or smaller hole.
(1) Insert the drill bit into the chuck.
(2) Use the chuck key to secure the drill bit, tightening the
chuck by each of the three holes in turn. (Fig. 5)

HOW TO USE

How to make the batteries perform longer
○ Recharge the batteries before they become completely
exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its battery. If
you continue to use the tool and exhaust the electric
current, the battery may be damaged and its life will
become shorter.
1. Mode selection and rewriting functions
The operation mode is switched each time you press the
mode selection switch provided on the side of the tool
body.
Select an operation mode corresponding to your desired
operation (Fig. 6).
NOTE:
The mode selection can be switched only after installing
the charger to the body and once pulling the switch.
(1) Default setting for operation mode
The following four modes are set as default operation
mode on this machine.
Symbol Operation mode
A Electronic pulse "3"
B Bolt "Continuous"
C Self drilling screw "2"
D Drill
10
Example of applicable operation
Tightening of wood screws
Tightening of bolts
Tightening of
self drilling screw
Drilling
NOTE:
○ The tightening torque obtained in an actual tightening
operation varies with the screw or clamping member
used.
Try to tighten a few screws to confi rm the appropriate
tightening torque.
○ Use the Bolt mode to tighten bolts.
○ Mode switching is impossible if the mode selection
switch is operated with the switch turned on. Be sure to
turn off the switch before performing mode switching.
(2) Built-in operation modes and mode rewriting
function of this product
The machine includes 20 operation modes in total. The
setting of each mode is described below.
You can freely select up to four operation modes by using
an optional communication adaptor. It is also possible to
limit the number of switchable modes to one or two, or to
set all of the four modes to a same operation mode.