Water And Ice Dispensers - Viking D3 RDFN536D Use & Care Manual

Ice Maker and Ice Storage Bin
Remember
• The quality of your ice will be only as good as the quality of the
water supplied to the ice maker. AVOID connecting the ice maker
toa softened water supply. Water softener chemicals (such as salt)
can damage parts of the ice maker and lead to poor quality ice. If a
softened water supply cannot be avoided, make sure the water
softener is operating properly and is well maintained.
• DO NOT use anything sharp to break up the ice in the bin. This can
cause damage to the ice bin and dispenser mechanism.
• DO NOT store anything on top of the ice maker or in the ice storage bin.

Water and Ice Dispensers

IMPORTANT:
• After connecting the refrigerator to a water source or replacing the
water filter, flush the water system. Use a sturdy container to depress
and hold the water dispenser lever for 5 seconds, then release it for
5 seconds. Repeat until water begins to flow. Once water begins to
flow, continue depressing and releasing the dispenser paddle (5
seconds on, 5 seconds off) until a total of 4 gal. (15 L) has been
dispensed. This will flush air from the filter and water dispensing
system, and prepare the water filter for use. Additional flushing may
be required in some households. As air is cleared from the system,
water may spurt out of the dispenser.
• Allow 24 hours for the refrigerator to cool down and chill water.
• The dispensing system will not operate when refrigerator door is open.
Calibrate Measured Fill
Low water pressure may affect the accuracy of the Measured Fill
feature. So, for optimum performance of your water dispenser, you
must first calibrate Measured Fill.
IMPORTANT: Flush the water system
before calibrating Measured Fill.
1. Place a sturdy measuring cup (1 cup
size) on the dispenser tray centered in
front of the water dispenser paddle.
14
All manuals and user guides at all-guides.com
(cont.)
A
B
A. Water dispenser paddle
B. Measuring cup (1 cup)
Water and Ice Dispensers
2. Press and hold the OPTIONS and LOCK buttons at
the same time for 3 seconds. The words "Back" and
"1 Cup" will appear on the display screen. Also, the
Calibrate Measured Fill icon will illuminate and
remain lit while the Measured Fill feature is being
calibrated
NOTE: You may press the ICE MODE button under the word "Back"
at any time to exit calibration mode. The Calibrate Measured Fill
icon will turn off.
3. Press and release the water dispenser paddle, as
needed, to dispense water to the 1 cup fill line.
NOTE: If overfilling or spilling occurs, discard
the water and press "Back" to restart the
calibration process.
4. When 1 cup of water has been correctly
dispensed into the measuring cup, press the
MEASURED FILL button under the word
"Confirm" to confirm the calibration.
5. When Measured Fill calibration has been
confirmed the icons will disappear and the
display will return to the home screen.
15
(cont.)
A
A. 1 cup of water