Ice And Water Dispenser Bezel Removal - Viking DFBB536 Installation Manual

Ice and Water Dispenser Bezel Removal

5
Remove 2 additional screws under
top section of bezel.
7
Grasping the bezel on both sides, pull away
from the door cavity.
Note: Bezel needs to be pulled from the bottom
first and then pull slightly downward to clear
the water dispensing tube.
For re-installation steps, see pages 52-53.
48
(if required cont.)
6
Remove mounting support.
3 8
Store bezel and spill tray in safe and secure place
until installation.
Custom Door Panel Installation
(Refrigerator or Freezer)
1
x13
Remove handle side cabinet screws
and trim with a phillips screwdriver.
3
Remove FOL bracket.
5
x13
x12 BTM
x13 SxS, AFAR
Attach "Z" bracket to the hinge side of custom panel.
Attach FOL bracket to the handle side of custom panel.
49
2
x2
x13
x2
Remove all screws from handle side door trim.
Remove two screws from top and bottom door trim.
Remove handle side door trim.
4
2-1/16" 2-1/16" 1-23/32" 1-23/32"
(5.2 cm) (5.2 cm) (4.4 cm) (4.4 cm)
2-13/16" 2-13/16"
(7.1 cm) (7.1 cm)
Bottom-mount Bottom-mount
12-1/16" 12-1/16"
2-9/64" 2-9/64" 2-9/64"
(30.6 cm) (30.6 cm)
(5.4 cm) (5.4 cm) (5.4 cm)
All Refrigerator/ All Refrigerator/
Freezer/ Freezer/
Side-by-side Side-by-side
Back of panel Back of panel
"Z" bracket "Z" bracket FOL bracket FOL bracket
Measure and mark the first hole for each bracket.
6
Push custom wood panel onto door.