Custom Side Panel Dimensions; Custom Panel General Information; Ice And Water Dispenser Bezel Removal - Viking DFBB363 Installation Manual

Custom Side Panel Dimensions

4 "
- 3 /
)
2 1
c m
. 2
( 5 5
8 2
( 2 1
- 7 /
0 . 5
8 "
c m
) m
t o
8 4
i n .
( 2 1
- 1 /
3 . 5
1 6
c m "
) m
a x
. *
Note: Adding 3/4"
(1.9 cm) side panels
"
2 4
)
adds an additional
c m
. 0
3/4" (1.9 cm) to the ( 6 1
overall width of the
product for each side
panel used.
Note: Requires side
panel hardware kit
(SPHKDS).
Optional kickplate notch
Dimensions determined by cabinets
* Depending on how high leveling feet are raised, and cabinet enclosure height.
45
1"
Z-Bracket
(2.5 cm)
1/4"
(0.6 cm)
3/4"
(1.9 cm)
End panel
4 "
- 3 /
)
2 1 c m
. 2
( 5 5
8 2
( 2 1
- 7 /
0 . 5
8 "
c m
) m
8 4 t o
i n .
( 2 1
- 1 /
3 . 5
1 6
c m "
) m
a x
. *
"
2 4
)
c m
. 0
( 6 1

Custom Panel General Information

Custom finishing options
• All installations must allow for the refrigerator ad freezer door to open a minimum of 90˚.
• For side wall or corner installation, allow for a standard 3" (7.6 cm) cabinet filler to assure
door(s) open 90˚.
Note: If a custom handle is used a wider filler may be necessary.
• Panel thickness must not exceed 1"
(2.5 cm) on hinge side. Thicker panels will interfere with door swing and clearance.
• A 1/4" wood filler or insulation filler must be used between the door and 3/4" wood panel to
prevent condensation from forming.
Ice and Water Dispenser Bezel Removal (if required)
1
Remove packaging material surrounding bezel.
3
Remove spill tray form lower part of bezel
exposing two screws.
46
2
Grasping the sliding lever, pull away from bezel.
4
Remove screws.