Handset Reset; Subscribing A Handset On A Base Station - Topcom BUTLER 5070 User Manual

Butler 5070
- Press OK to confirm.
- Select CHANGE PIN by using the UP- and DOWN keys.
- Press OK to confirm.
- Enter the old Pin code: OLD PIN:
- Press OK to confirm.
- Enter the new Pin code: NEW PIN:
- Press OK to confirm.
- Re-enter the new Pin code: NEW PIN:
- Press OK to confirm.
- Press ESC to leave the menu.
7.9.

Handset Reset

The standard settings are:
Display language:
Handset Pin:
Redial List:
Call List:
Baby Call:
Battery low alert:
Key Click:
Out Of Range signal:
Direct memories:
Knocking Tone :
To reset the handset to its standard settings:
- Press MENU when the unit is in standby mode..
- Select SECURITY HS by using the UP- and DOWN keys.
- Press OK to confirm.
- Select RESET by using the UP- and DOWN keys.
- Press OK to confirm.
- The display shows SURE?
- Press OK to confirm or ESC to leave the setting.

7.10. Subscribing a handset on a base station

Every new handset must be subscribed onto the base station before you can make a phone call.The
included handset is already subscribed.
If you want to subscribe a new handset on the bases station or when you have unregistered the hand-
set, the base set must be set in subscription mode.
You will need the PARK CODE. This is the 15 digit code, which you can find at the bottom of the
base station.
- Press the paging-button on the base station for more than 10 seconds. The base station will be in
subscription mode for 5 minutes.
- Press MENU when the unit is in standby mode..
- Select SYSTEM by using the UP- and DOWN keys.
- Press OK to confirm.
- Select SUBSCRIPTION by using the UP- and DOWN keys.
- Press OK to confirm.
- Press OPT. (option)
- Select NEW by using the UP- and DOWN keys.
- Press OK to confirm.
English
0000
Empty
Empty
Off
On
On
On
Empty
On
81