Remote Control - Inserting Batteries; Switching The Tv On And Off - Bush LE-55GV350-B1 Instruction Manual

Getting Started
You'll be up and running in no time

Remote control - Inserting batteries

Remove the battery cover on the back of the remote
control, gently push down and pull backwards at the
same time as shown.
Insert two AAA/R3 or equivalent type batteries. Ensure
the batteries are inserted the correct way and replace the
battery cover.
Note: When the remote control is not going to be used
for long periods of time, the batteries should be removed.
Otherwise the remote control may be damaged, caused
by battery leakage and corrosion.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Getting Started
18

Switching the TV On and Off

Switching the TV On
With power cord plug connected to the mains power
socket and TV in 'Standby' mode.
To switch the TV on from standby mode, either:
a: The Remote control; Press the "
b: The TV; Press the "
bottom of the TV.
Switching the TV Off
Either press the "
control or press the "
the TV will then switch to standby mode.
AAA/R3 X2
Batteries
" button.
" button at the
" button on the remote
" button at the bottom of the TV,