Table of Contents
Advertisement
Getting to know your TV
You'll be up and running in no time
the creator originally intended with different ambient
lighting conditions.
Licence Notification
The terms HDMI, HDMI High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or registered
trademarks of HDMI Licensing Administrator, Inc.
Dolby, Dolby Vision, Dolby Audio, and the double-D
symbol are trademarks of Dolby Laboratories Licensing
Corporation. Manufactured under licence from Dolby
Laboratories. Confidential unpublished works. Copyright
© 1992-2020 Dolby Laboratories. All rights reserved.
YouTube and the YouTube logo are trademarks of Google
Inc.
For DTS patents, see http://patents.dts.com. Manufactured
under licence from DTS Licencing Limited. DTS, the
Symbol, & DTS and the Symbol together are registered
trademarks, and DTS TruSurround is a trademark of DTS,
Inc.
DTS, Inc. All Rights Reserved.
©
For DTS patents, see http://patents.dts.com. Manufactured
under licence from DTS Licencing Limited. DTS, DTS-HD,
the Symbol, & DTS or DTS-HD and the Symbol together
are registered trademarks of DTS, Inc.
Reserved.
DVB is a registered trademark of the DVB Project.
[1] EIA/CEA-861-D compliance covers the transmission
of uncompressed digital video with high-bandwidth
digital content protection, which is being standardized for
reception of high-definition video signals. Because this is
an evolving technology, it is possible that some devices
may not operate properly with the television.
This product contains technology subject to certain
intellectual property rights of Microsoft. Use or distribution
of this technology outside of this product is prohibited
without the appropriate licence(s) from Microsoft.
Content owners use Microsoft PlayReady™ content
access technology to protect their intellectual property,
including copyrighted content. This device uses
PlayReady technology to access PlayReady-protected
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.co.uk. If you still require further assistance, call one of our experts on 0345 604 0105, a Bush enquiry line.
content and/or WMDRM-protected content. If the device
fails to properly enforce restrictions on content usage,
content owners may require Microsoft to revoke the
device's ability to consume PlayReady-protected content.
Revocation should not affect unprotected content or
content protected by other content access technologies.
Content owners may require you to upgrade PlayReady to
access their content. If you decline an upgrade, you will
not be able to access content that requires the upgrade.
The "CI Plus" Logo is a trademark of CI Plus LLP.
This product is protected by certain intellectual property
rights of Microsoft Corporation. Use or distribution of such
technology outside of this product is prohibited without
a licence from Microsoft or an authorised Microsoft
subsidiary.
Antenna Connection
Connect the aerial TV plug to the AERIAL INPUT (ANT-TV)
socket located on
Rear side of the TV
connection is done, you can turn on the units and use
them.
DTS, Inc. All Rights
©
Inserting the Batteries into the Remote
Remove the back cover to reveal the battery compartment.
You need to do the followings in order to do that:
• Place the tip of a pen or some other pointed object in
the hole above the cover and press it down.
• Then press firmly on the cover and slide in the direction
of the arrow.
Insert two size AAA batteries. Make sure the (+) and (-)
signs match (observe correct polarity). Do not mix old
and new batteries. Replace only with same or equivalent
type. Place the cover back on.
A message will be displayed on the screen when the
batteries are low and must be replaced. Note that when
the batteries are low, the performance of the remote
control may be impaired.
Batteries should not be exposed to excessive heat such
as sunshine, fire or the like.
the rear side of
the TV.
ANT-TV
If you want to connect a device to the TV, make
sure that both the TV and the device are turned
off before making any connection. After the
Getting to know your TV
11
Advertisement
Table of Contents
