Aerial Connection; Power Connection; Remote Control - Inserting Batteries; Wall Mounting - Bush LED24970FHDS Installation & Operating Instructions Manual

Getting Started

Aerial connection

Connect the "aerial" or "cable TV" plug to AERIAL
INPUT (ANT.) socket located on the back of the
TV (fi g.1).

Power connection

IMPORTANT :The TV set is designed to operate on
220-240V AC, 50 Hz.
Please note: After unpacking, allow the TV to reach
ambient room temperature before connecting the TV
to the mains power socket.
Connect the power cord plug to the mains power
socket.
The LED on the front of the TV then lights up, this
indicates that the TV is in 'Standby' mode.
Remote control -
Remove the battery cover on the back of the remote
control, gently push down and pull backwards at the
same time as shown.
Insert two AAA/R3 or equivalent type batteries. Ensure
the batteries are inserted the correct way and replace
the battery cover (fi g.2).
NOTE: When the remote control is not going to
be used for long periods of time, the batteries should
be removed. Otherwise the remote control may be
damaged, caused by battery leakage and corrosion.

Wall Mounting

When wall mounting please ensure you use a compatible
wall mount (not supplied). This TV conforms to the VESA
mounting specifi cations and is 75 x 75 mm.

Switching the TV On and Off

Switching the TV On

With power cord plug connected to the mains power
socket, the TV is in 'Standby' mode.
To switch the TV on from standby mode:
Connect the power cord to the 220-240V AC 50 Hz.
Then the standby LED lights up. (The led will blink
during the standby On/Off)
To switch on the TV from standby mode either:
a. Press the button, P+ / P- or a numeric button on
" "
the remote control.
b. Press the - or + button of the TV.
" ",
By either method the TV will switch on.
For any help concerning set up and use of your TV please call the Customer Helpline: 0845 604 0105
Inserting batteries
AAA/R3 x 2
Batteries

Switching the TV Off

Press the " " button on the remote control or press
the " " switch on the TV, the TV will switch to standby
mode.
To turn off the TV completely, remove the power
cord plug from the mains power socket.
NOTE: When the TV is in standby mode, the standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active.
NOTE: If you switch on your TV via P +/- buttons on
the remote control or +/- on the TV set, the programme
that you were watching last will be reselected.
fi g.1
fi g.2
11