Table of Contents
Advertisement
Entertainment Features
Let's get started
USING THE USB FEATURES
1. Always switch the TV off before attaching a USB
storage device to your TV.
2. Connect the USB storage device to one of the USB
ports on your TV.
3. Press the
button on the remote control or TV to
turn the TV on.
4. Press the Menu button on your remote control. Use
buttons to select USB MEDIA from menu
the
then press the OK button to open.
IMPORTANT: Some portable USB hard disks may require
more power than the TVs USB port can supply. To
ensure the correct operation of the USB hard disk please
use an appropriate power adapter with the hard disk.
If you are using a USB Hub, please ensure its mains
adapter is connected to the mains supply as the
total current consumption may exceed 500mA, the
maximum the TV can supply.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Entertainment Features
50
The file system only supports FAT32 format.
If you want to keep recorded DTV programmes the
transfer rate of the storage device must not be less
than 5MB/s, otherwise the picture and sound of the
programme will be affected and a warning statement
will be shown on the TVs screen. If this happens please
upgrade your USB storage device.
Your TV screen will go temporarily blank when you
start recording as it takes a few seconds to stabilize the
connection to the USB storage device.
Always disconnect the USB storage device if it is not
going to be used for extended periods.
Advertisement
Table of Contents
