Maytag Ice2O Series Use & Care Manual page 7

Installation
Door Reinstallation
1. Install hinge assemblies:
• Install center hinges with Phillips or hex screws.
2. Place hinge side of refrigerator
door on center hinge pin.
• Install top hinge with 5/,6"hex
head screws.
3. While holding refrigerator door upright, tighten
down top hinge with _,6" hex head driver.
4. Reconnect connector.
5. Connect the waterline tubes firmly by pushing one
waterline inside the other.
6. Slide the black locking collar fully forward.
7. Hold tabbed section of
waterline.
8. Rotate black locking collar
counterclockwise locking
water lines in place. A
tabs
"click" is heard ensuring
waterlines are correctly
locked in place. The "arrow"
on the tabbed section
should align with the 2 bars
on the black locking collar. .
9. Ensure the connection does not leak before
installing the upper hinge cover.
10. Replace top hinge covers.
Pullout Freezer Drawer
To Remove:
1. Pull drawer open to full
extension.
2. Slide freezer bins forward and
lift straight out.
3. Remove Phillips screws from
each of the drawer slides.
'_iiiiiiiii}ii{{i}ii_ii!;!i!i_i{_i!i!iii ¸!¸¸¸_¸¸ i
, , 4ii
.
Lift top of drawer front to
unhook the drawer from the
slides.
5. Move drawer slides fully
forward.
6. Lift out lower drawer assembly.