Ncduevox Voice Board - Bentel Security Omnia 8/L Manual

NCDUEVOX voice board

Step 1
Step 2
Step 3
Step 4
Figure 3
How to attach the board
Disconnect the Mains and battery before attaching the NCDUEVOX board
to a Panel that is in service.
Attach the NCDUEVOX board as follows (see also figure 3).
Remove the strip of paper from the self-adhesive gasket (47) and position
the gasket in the centre of the four holes on the back box, as per figure 3.
Slot the NCDUEVOX voice board into its holder----microphone to the top.
Connect the NCDUEVOX cable (40) to the connector (4) on the Panel board.
When the NCDUEVOX board is properly attached----complete the connec-
tions then power the Panel, and record the alarm messages, as per the in-
structions in the INSTALLATION MANUAL.
The optional OmniaVox-MS and Speaker will allow Remote Listen-in on
ambients, other than that of the Panel. Locate the OmniaVox-MS and
Speaker as required then complete the connections with the Voice Board
(use shielded cable only). Refer to the Installation Manual.
Attaching the NCDUEVOX board
ISTUCBLEOMNIA8-L 1.1 260601 V4.2 BUUC
4
40
47